› ›

DeJe

About

Username
DeJe
Joined
Visits
46
Last Active
Roles
Member

Comments

  • @Repetier, thanks for answering. I just saw in the firmware you have XY compensation implemented. Am I right it will also work with CoreXY printers? I will try this tonight. That feature I was looking for. Just a few more questions.- I think I did …
    in Calibrating CoreXY Comment by DeJe February 2017
  • Thanks.But as I said already I had no much success in tighten the belts. I would rather like to have a compensation value for X(A) or/and Y(B) to be set. So the question goes to @Repetier if that would be in any way possible. best regards,DeJe
    in Calibrating CoreXY Comment by DeJe February 2017
  • Yes I know it's not officially supported. But it works great here cause the RAMPS is OK (for little money) for my HW and the due can handle the speed I need (CoreXY, dual extruder, Display, ...). I downloaded the complete Package from the configura…
    in Second extruder not moving Comment by DeJe October 2016
  • OK, I found ... a bug in the firmware. In pins.h and motherboard type "401" (Arduino Due) ORIG_E1_ENABLE_PIN is defined as "40".This is wrong and schould be "30". I changed and second extruder is working as expected. Thanks for reading. PS: should…
    in Second extruder not moving Comment by DeJe October 2016
  • I read the values on the printer display.
    in Coordinates could go wrong if manually controlled Comment by DeJe April 2016
  • Never mind...it was my fault. I had the motors connected to the wrong terminals. I changed the motors for X and Y terminals and now it works as expected. Origin is left/front now. Regards,DeJe
    in Set X/Y origin correctly with Firmware Comment by DeJe January 2016