zastrowc@uwplatt.edu
About
- Username
- zastrowc@uwplatt.edu
- Joined
- Visits
- 15
- Last Active
- Roles
- Member
Comments
-
After attempting to print again, I discovered that the extruder motor was skipping. I increased the current on the driver and the extruder is now working properly. However, I am not able to heat up the extruder via the manual control button on Host …
-
I only have one printer without a SD card and a computer connected via USB as of now (I usually use Server). When I heat the extruder via LCD, target temperature is reached and held (see attached picture). I changed my heat manager to PID just to ve…
-
Here are the EEPROM and Host settings that relate to the extruder.
-
I have enabled commands. The log in the attached picture shows the startup connection and then the attempt to heat the extruder. After the M104 command, I don't see anything besides the command to read temperature and certainly don't see something t…
-
I will attach screenshots of both the temperature curve and the log. The spikes in the temperature curve correspond to me attempting to heat the extruder via host. Notice how the power cuts off very soon after it starts.
-
It is also worth mentioning that I am not able to manually extrude filament when the extruder is heated correctly. It is almost like the printer is in dry mode but I have it unchecked in Host. Any help is greatly appreciated.
-
Thanks for the quick and clear response. That simple fix worked.