There are gaps in the printed model layers
edited April 18
Is there a problem with my printer z-axis or slicing software? How are the default settings for the slicing software for Kossel mini?
I think the filament flows very little between the first and last layers.
There are no default settings it all depends on what you have, which nozzle size etc. Assuming printer is calibrated you may have to modufy flow multiplier for filament to extruder more if lines come out too thin, that is all.
edited April 18
Flow multiplier for filament ? Is it from memory or software?
Extruder step :357
Filament flow rate from extruder is normal.
Filament release rate is% 106
Our questions seem very absurd to you. But I try to understand. Thank you for your interest.
In slic3r it is in filament settings. You can also use flow multipler in host/server to test how it looks if flow is increased. Increasing it pushes mor efilament so it gets broader closing gaps.
You might also want to reduce extrusion width in slic3r settings. I have for my 0.5mm nozzle set extrusion with explicitly to 0.5 so it does not broaden by slic3r choice. But that means longe rprint times so personal liking.
edited April 19
Benim örnek çıktıım yazıcıdan çıktı.
I have to increase the number of layers of the base coat while printing a large pattern on the printer tray. I set all of the axes to a distance of 0.5 to 0.3. I think this is normal.
My 3d Printer:
"increase the number of layers of the base coat" is nothing I can understand.
First layer is 0.3 for my delta, all following layers 0.2-0.1mm depending on quality I want. This is with 0.4mm nozzle.